Reebok Watch W 113 User Guide

INDIGLO® NIGHT-LIGHT  
Press button or crown to activate light. Patented (U.S. pat. 4,527,096 and  
4,775,964) electroluminescent technology used in the INDIGLO® night-  
light illuminates entire watch face at night and in low light conditions.  
W-113 905-095012  
BRACELET ADJUSTMENT  
SLIDING CLASP BRACELET  
Open locking plate. Move clasp to desired bracelet  
length. Exert pressure while holding locking plate  
and slide clasp back and forth until it engages in  
grooves on underside of bracelet. Press locking  
plate down until it snaps closed. Clasp can be damaged if excessive  
force is used.  
THANK YOU FOR PURCHASING YOUR REEBOK® WATCH.  
Please read instructions carefully to understand how to operate  
your Reebok® watch. Your model may not have all of the  
features described in this booklet.  
FOLDOVER CLASP BRACELET  
Find spring bar that connects bracelet to clasp. Using a pointed tool  
(Fig. 1), push spring bar in and gently twist bracelet to disengage.  
Determine wrist size, then insert spring bar in correct bottom hole  
(Fig. 2). Push down on spring bar, align with top hole and release to lock  
in place (Fig. 3).  
CROWN  
Fig. 1  
Fig. 3  
Fig. 2  
BRACELET LINK REMOVAL  
CROWN  
Removing Links: Place bracelet upright  
and insert pointed tool in opening of link.  
Push pin forcefully in direction of arrow  
until link is detached (pins are designed to  
be difficult to remove). Repeat until desired  
number of links are removed.  
START WATCH  
Important: Set day and date first! Remove guard from crown and push  
in. For screw-in setting crown, turn COUNTERCLOCKWISE to loosen.  
Note: Crown can be located at 3 o’clock or 6 o’clock position.  
Reassembly: Rejoin bracelet parts. Push pin back into link in opposite  
direction of arrow. Press pin down securely into bracelet until it is flush.  
SET TIME  
Pull crown all the way out and turn to correct time. Push crown in to  
restart. For screw-in setting crown, push crown in while turning CLOCK-  
WISE to tighten.  
Watches with date: Note correct time of day (A.M. or P.M.) for proper  
date function.  
SOLID LINK BRACELET  
Removing Links: Using a very small screw-  
driver, remove screws by turning counter-  
clockwise. Repeat until desired number of  
links are removed. Do not remove links adja-  
cent to clasp.  
SET DAY  
Reassembly: Rejoin bracelet parts and  
insert screw in end of opening where it was removed. Turn screw clock-  
wise until tight and flush with bracelet.  
Pull crown to “middle” position and turn CLOCKWISE until correct day  
appears. If day does not change, pull crown to “out” position and turn  
CLOCKWISE or COUNTERCLOCKWISE through necessary number of 24  
hour periods until correct day appears.  
WATER AND SHOCK RESISTANCE  
IN  
MIDDLE  
OUT  
WED 14  
WED 14  
WED 14  
WARNING: TO MAINTAIN WATER-RESISTANCE, DO NOT PRESS ANY  
BUTTONS OR PULL OUT THE CROWN UNDER WATER UNLESS YOUR  
WATCH IS INDICATED AS 200 METER WATER-RESISTANT.  
1. Watch is water-resistant only as long as crystal, crown and case  
remain intact.  
SET DATE “FAST DATE”  
3-Position Crown: Pull crown to “MIDDLE” position and turn CLOCK-  
WISE or COUNTERCLOCKWISE until correct date appears.  
2-Position Crown: Pull crown to “OUT” position and turn CLOCKWISE  
until date changes. Repeat until correct date appears. Adjust date when  
month has less than 31 days. Push crown in when finished.  
2. Watch is not a diver watch and should not be used for diving.  
3. Screw-in setting crown and case back must be screwed into case to  
assure water-resistance (see Set Time). (Optional)  
4. Rinse watch with fresh water after exposure to salt water.  
5. Shock-resistance will be indicated on watch face or caseback.  
Watches are designed to pass ISO test for shock-resistance. However  
avoid damaging crystal/lens.  
NOTE: Date may need to be manually  
updated at the end of each month by  
following above procedure (otherwise  
it will continue to 39 and then roll  
over to 00).  
14  
If your watch is water-resistant, meter marking or (  
) is indicated.  
Water-Resistance Depth  
p.s.i.a.* Water Pressure Below Surface  
30m/98ft  
50m/164ft  
100m/328ft  
200m/656ft  
60  
86  
160  
284  
ROTATING TIME RING (OPTIONAL)  
Position symbol () at desired time to start or end activity.  
*pounds per square inch absolute  
BATTERY  
Tide ring  
Elapsed ring  
Reebok strongly recommends that a retailer or jeweler replace bat-  
tery. If applicable, push reset button when replacing battery. Battery type  
is indicated on caseback. Battery life estimates are based on certain  
assumptions regarding usage; battery life may vary depending on actual  
usage.  
COMPASS DIRECTIONAL RING (OPTIONAL)  
To get approximate compass reading, point  
12  
1
5
11  
10  
9
hour hand at sun. Adjust ring so S (South) is  
halfway between hour hand and 12. Adjust  
every hour. Make sure hour hand is always  
pointed towards the sun.  
2
3
4
DO NOT DISPOSE OF BATTERY IN FIRE. DO NOT RECHARGE. KEEP  
LOOSE BATTERIES AWAY FROM CHILDREN.  
8
7
6
N
 

QSC Audio Portable Speaker HPR122i User Guide
QUAD Stereo Amplifier QUAD 2 User Guide
RCA Clock Radio RP 3761 User Guide
Rosewill Bread Maker R BM 01 User Guide
Ruud Water Heater AP13370 2 User Guide
Samsung Cell Phone SPH m540 User Guide
Samsung Microwave Oven CM1019 User Guide
Samsung Projection Television HCM4715W User Guide
Scytek electronic Automobile Alarm 2000RS User Guide
Sears Impact Driver 73311 User Guide